HPLC-MS is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Last reviewed on 2025-12-25. Where a claim depends on a specific study, the study is described rather than over-claimed.
Laboratory identification of SR9009 typically relies on chromatographic separation coupled to mass spectrometry, often with ultraviolet detection as a secondary check. Nuclear magnetic resonance spectroscopy can confirm molecular structure when a reference standard is available. Because many suppliers sell the compound as a research chemical, independent identity testing is important for experimental reproducibility. A single retention time is not sufficient proof of identity, especially when related compounds may be present. Purity assessments usually report a percentage based on area normalization.
SR9009 is generally described as poorly soluble in water and more soluble in organic solvents such as dimethyl sulfoxide and ethanol. Stock solutions are commonly prepared in an organic solvent before dilution into an aqueous buffer or vehicle. Precipitation can occur if the organic fraction is reduced too quickly or if the final concentration exceeds the compound's solubility limit. Sonication or gentle warming may aid dissolution in some protocols, but excessive heat can promote degradation. Container material and pH can also influence observed solubility.
In laboratory settings, SR9009 is commonly identified by its molecular structure and its interaction with REV-ERB receptors. Vendors may list it under synonyms such as Stenabolic or REV-ERB agonist, but those names do not define purity or identity. Analytical confirmation typically uses high-performance liquid chromatography with ultraviolet detection or liquid chromatography–mass spectrometry. A reference standard is needed to compare retention time and mass spectrum, because the compound can be confused with related research chemicals.
Handling practices for SR9009 focus on minimizing degradation and contamination. The solid is generally stored desiccated at or below -20 °C, protected from light and moisture. Stock solutions are often prepared in dimethyl sulfoxide or ethanol, then aliquoted to avoid repeated freeze–thaw cycles. Aqueous solubility is low, so formulations for animal studies may require cosolvents or suspending agents. Personnel should follow institutional chemical safety procedures, because toxicological data for humans are incomplete.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Visual inspection is not sufficient for identity. |
| Solubility | Soluble in DMSO and ethanol | Low solubility in water; stock solutions use organic solvent. |
| Storage | -20°C, desiccated, protected from light | Limits hydrolysis and photodegradation. |
| Analytical method | HPLC-UV/MS | Used for identity and purity assessment. |
| Synonyms | SR9009, Stenabolic | Naming varies by supplier. |
In rodent studies, SR9009 has been reported to increase mitochondrial content in skeletal muscle and improve exercise endurance under some conditions. These findings led to popular descriptions such as an exercise mimetic, although that term oversimplifies the biology. Effects vary by dose, timing, tissue, and model. The compound's influence on circadian pathways means that time of administration can matter in experiments. Whether similar metabolic changes occur in humans remains largely unexplored in controlled published trials.
Pharmacokinetic data for SR9009 are limited in published literature. Some reports indicate low oral bioavailability and rapid clearance in animals, which complicates interpretation of exposure and effect. Researchers often use injected routes in preclinical work to achieve measurable systemic levels. Analytical studies rely on mass spectrometry to detect the parent compound and its metabolites. Questions about tissue distribution, active metabolites, and long-term consequences remain open. Species differences in metabolism can affect observed half-life and target engagement.
Lipofuscin appears to be the product of the oxidation of unsaturated fatty acids and may be symptomatic of membrane damage, or damage to mitochondria and lysosomes. Aside from a large lipid content, lipofuscin is known to contain sugars and metals, including mercury, aluminium, iron, copper and zinc. Lipofuscin is also accepted as consisting of oxidized proteins (30–70%) as well as lipids (20–50%). It is a type of lipochrome and is specifically arranged around the nucleus. The accumulation of lipofuscin-like material may be the result of an imbalance between formation and disposal mechanisms. Such accumulation can be induced in rats by administering a protease inhibitor (leupeptin); after a period of three months, the levels of the lipofuscin-like material return to normal, indicating the action of a significant disposal mechanism. However, this result is controversial, as it is questionable if the leupeptin-induced material is true lipofuscin. There exists evidence that "true lipofuscin" is not degradable in vitro; whether this holds in vivo over longer time periods is not clear.
Intranasal drug delivery occurs when particles are inhaled into the nasal cavity and transported directly into the nervous system. Though pharmaceuticals can be injected into the nose, some concerns include injuries, infection, and safe disposal. Studies demonstrate improved patient compliance with inhalation. Treating brain diseases has been a challenge due to the blood brain barrier. Previous studies evaluated the efficacy of delivery therapeutics through intranasal route for brain diseases and mental health conditions. Intranasal administration is a potential route associated with high drug transfer from nose to brain and drug bioavailability.
The energy associated with a particular wavefunction, perhaps the most important information contained in a wavefunction, can be extracted by solving the Schrödinger equation (above, Ψ is the wavefunction, E is the energy, and Ĥ is the Hamiltonian operator) in which an appropriate Hamiltonian operator is applied. In the various forms of the Schrödinger equation, the overall size of a particle's probability distribution increases with decreasing particle mass. For this reason, nuclei are of negligible size in relation to much lighter electrons and are treated as point charges in practical applications of quantum chemistry. Due to complex interactions which arise from electron-electron repulsion, algebraic solutions of the Schrödinger equation are only possible for systems with one electron such as the hydrogen atom, H2+, H32+, etc.; however, from these simple models arise all the familiar atomic (s,p,d,f) and bonding (σ,π) orbitals. In systems with multiple electrons, an overall multielectron wavefunction describes all of their properties at once. Such wavefunctions are generated through the linear addition of single electron wavefunctions to generate an initial guess, which is repeatedly modified until its associated energy is minimized. Thousands of guesses are often required until a satisfactory solution is found, so such calculations are performed by powerful computers. Importantly, the solutions for atoms with multiple electrons give properties such as diameter and electronegativity which closely mirror experimental data and the patterns found in the periodic table.
Sources: en.wikipedia.org
=== Thermospray interface === The thermospray (TSP) interface was developed in 1980 by Marvin Vestal and co-workers at the University of Houston. It was commercialized by Vestec and several of the major mass spectrometer manufacturers. The interface resulted from a long-term research project intended to find a LC–MS interface capable of handling high flow rates (1 ml/min) and avoiding the flow split in DLI interfaces. The TSP interface was composed of a heated probe, a desolvation chamber, and an ion focusing skimmer. The LC effluent passed through the heated probe and emerged as a jet of vapor and small droplets flowing into the desolvation chamber at low pressure. Initially operated with a filament or discharge as the source of ions (thereby acting as a CI source for vapourized analyte), it was soon discovered that ions were also observed when the filament or discharge was off. This could be attributed to either direct emission of ions from the liquid droplets as they evaporated in a process related to electrospray ionization or ion evaporation, or to chemical ionization of vapourized analyte molecules from buffer ions (such as ammonium acetate). The fact that multiply-charged ions were observed from some larger analytes suggests that direct analyte ion emission was occurring under at least some conditions. The interface was able to handle up to 2 ml/min of eluate from the LC column and would efficiently introduce it into the MS vacuum system. TSP was also more suitable for LC–MS applications involving reversed phase liquid chromatography (RT-LC).
==== Café La Crème shooting ==== In 2017, two masked hitmen fired shots at the Café La Crème in Marrakech, killing Hamza Chaib, a 26-year-old medical student, and injuring two others. A Glock 19 and a motorcycle used by the hitmen to flee were found charred nearby. The hitmen were identified by the Marrakech Prefecture Judicial Police as Shardyone Ulises Girigorio Semerel, a 29-year-old Dutch-Surinamese national, and Edwin Gabriel Robles Martínez, a 24-year-old Dutch-Dominican national. Six other suspects were detained. They were known to Moroccan authorities for their involvement in cases of international drug trafficking, kidnapping, armed robbery, and attempted homicide. Their initial target was the owner of the lounge, Mustapha "Mous" el Fechtali, a member of the Bouyakhrichan clan involved in international money laundering. Moroccan authorities are known to use torture on suspects to gain information, leading to the hitmen quickly pointing out Taghi as their ringleader. The shooting led to a closer collaboration between the Dutch and Moroccan authorities to combat organised crime, especially towards Taghi's organisation. The hitmen were sentenced to death by the Marrakech Court of Appeal in 2019. Mustapha el Fechtali was sentenced to 15 years in jail for drug trafficking. An alleged coordinator, 33-year-old Seddik Rais, was freed after his extradition from the Canary Islands.
Pediatric asthma poses diagnostic challenges due to its variable presentation. Breath analysis could be a game-changer in pediatric allergic asthma management. By identifying unique exhaled metabolic signatures using SIRIUS, researchers developed an approach to diagnose children with allergic asthma. Thiacloprid is a first-generation, widely used, neonicotinoid insecticide. Its persistence in the environment and potential adverse effects on human health have raised significant concerns. Elucidating the impurity profile of pesticides is crucial for assessing their environmental impact and potential risks, and setting acceptable limits for impurities. Using SIRIUS, researchers demonstrated an approach for identifying structurally related impurities in pesticides. Under certain conditions, two bacterial species can thrive together in a dual-species biofilm. The cooperation between P. aeruginosa and S. aureus in cystic fibrosis leads to increased disease severity. Using SIRIUS, researchers identified a metabolite that could be related to the increased pathogenesis of this dual-species biofilm in cystic fibrosis. Our skin hosts a diverse community of microorganisms known as the skin microbiota. Using SIRIUS, researchers identified changes in the skin metabolome that are more pronounced than changes in the microbial composition, suggesting that even subtle shifts in microbial abundance can lead to significant effects on the skin.
== Research and development == In the 1970s, chemists at Dr. Karl Thomae GmbH, a subsidiary of Boehringer-Ingelheim in Germany, synthesized a variety of enol carboxamides with the aim of obtaining active ingredients with anti-inflammatory or antithrombotic properties. A compound belonging to the oxicams (UH-AC 62, meloxicam) stood out, exhibiting antiinflammatory activity in the pharmacological adjuvant arthritis model, but only low antithrombotic efficacy as measured by platelet aggregation. Dr. Karl Thomae GmbH filed the German basic patent DE2756113 (1979) and Boehringer Ingelheim US patent 4,233,299 (1980) and patents in many other countries.
Sources: en.wikipedia.org
== History == As early as the 17th century, the Spanish used quinine from the bark of Cinchona trees to treat malaria after being shown the remedy from the Indigenous peoples of Peru, Bolivia, and Ecuador. In early 19th century India and other tropical posts of the British Empire, medicinal quinine was recommended to British officials and soldiers to prevent malaria, where it was mixed with soda and sugar to mask its bitter taste, creating tonic water. The first commercial tonic water was produced in 1858 when a new invention "An improved aerated liquid" known as Quinine Tonic Water was patented by the owner of Pitt & Co., Erasmus Bond and manufactured at their Wharf Road, City Road London factory. The mixed drink gin and tonic also originated in British colonial India, when the British mixed their medicinal quinine tonic with gin and other ingredients to make the bitter medicine more palatable. Soldiers in India were already given a gin ration, so the concoction was easy to make. In 1868, the first known record of a gin and tonic was in the Oriental Sporting Magazine and was described as a refreshing cocktail for spectators of horse racing, not as a medicine.
=== Incandescent arc lamps === A variation of the incandescent lamp did not use a hot wire filament, but instead used an arc struck on a spherical bead electrode to produce heat. The electrode then became incandescent, with the arc contributing little to the light produced. Such lamps were used for projection or illumination for scientific instruments such as microscopes. These arc lamps ran on relatively low voltages and incorporated tungsten filaments to start ionization within the envelope. They provided the intense concentrated light of an arc lamp but were easier to operate. Developed around 1915, these lamps were displaced by mercury and xenon arc lamps.
These latter amino acids are therefore termed "ketogenic" amino acids, whereas those that enter the citric acid cycle as intermediates can only be cataplerotically removed by entering the gluconeogenic pathway via malate which is transported out of the mitochondrion to be converted into cytosolic oxaloacetate and ultimately into glucose. These are the so-called "glucogenic" amino acids. De-aminated alanine, cysteine, glycine, serine, and threonine are converted to pyruvate and can consequently either enter the citric acid cycle as oxaloacetate (an anaplerotic reaction) or as acetyl-CoA to be disposed of as CO2 and water. In fat catabolism, triglycerides are hydrolyzed to break them into fatty acids and glycerol. In the liver the glycerol can be converted into glucose via dihydroxyacetone phosphate and glyceraldehyde-3-phosphate by way of gluconeogenesis. In skeletal muscle, glycerol is used in glycolysis by converting glycerol into glycerol-3-phosphate, then into dihydroxyacetone phosphate (DHAP), then into glyceraldehyde-3-phosphate. In many tissues, especially heart and skeletal muscle tissue, fatty acids are broken down through a process known as beta oxidation, which results in the production of mitochondrial acetyl-CoA, which can be used in the citric acid cycle. Beta oxidation of fatty acids with an odd number of methylene bridges produces propionyl-CoA, which is then converted into succinyl-CoA and fed into the citric acid cycle as an anaplerotic intermediate.
Sources: en.wikipedia.org
Liquid chromatography with mass spectrometry is a common approach. Ultraviolet detection and nuclear magnetic resonance can support identification when suitable standards are available.
The solid is generally kept cold, dry, and protected from light. Solutions are often frozen in single-use aliquots to reduce repeated freeze-thaw cycles.
It indicates a material sold for laboratory study, not for human use. The label does not guarantee pharmaceutical purity, sterility, or regulatory approval.
Liquid chromatography–mass spectrometry is common for identity and purity checks. High-performance liquid chromatography with ultraviolet detection can also be used. Both methods require a suitable reference standard.