This is a working overview of freeze-thaw, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2026-04-27 and is reviewed periodically as new material appears.
Laboratory identification of SR9009 typically relies on chromatographic separation coupled to mass spectrometry, often with ultraviolet detection as a secondary check. Nuclear magnetic resonance spectroscopy can confirm molecular structure when a reference standard is available. Because many suppliers sell the compound as a research chemical, independent identity testing is important for experimental reproducibility. A single retention time is not sufficient proof of identity, especially when related compounds may be present. Purity assessments usually report a percentage based on area normalization.
SR9009 is generally described as poorly soluble in water and more soluble in organic solvents such as dimethyl sulfoxide and ethanol. Stock solutions are commonly prepared in an organic solvent before dilution into an aqueous buffer or vehicle. Precipitation can occur if the organic fraction is reduced too quickly or if the final concentration exceeds the compound's solubility limit. Sonication or gentle warming may aid dissolution in some protocols, but excessive heat can promote degradation. Container material and pH can also influence observed solubility.
In laboratory settings, SR9009 is commonly identified by its molecular structure and its interaction with REV-ERB receptors. Vendors may list it under synonyms such as Stenabolic or REV-ERB agonist, but those names do not define purity or identity. Analytical confirmation typically uses high-performance liquid chromatography with ultraviolet detection or liquid chromatography–mass spectrometry. A reference standard is needed to compare retention time and mass spectrum, because the compound can be confused with related research chemicals.
Handling practices for SR9009 focus on minimizing degradation and contamination. The solid is generally stored desiccated at or below -20 °C, protected from light and moisture. Stock solutions are often prepared in dimethyl sulfoxide or ethanol, then aliquoted to avoid repeated freeze–thaw cycles. Aqueous solubility is low, so formulations for animal studies may require cosolvents or suspending agents. Personnel should follow institutional chemical safety procedures, because toxicological data for humans are incomplete.
Regulatory status varies by country and intended use. Major drug agencies have not granted marketing authorization for SR9009 as a medicine, and it is not listed as a controlled substance in many jurisdictions. It is often sold as a research chemical, a category that may fall outside pharmaceutical manufacturing rules. Buyers should verify local laws and supplier documentation, including certificates of analysis. The lack of standardized quality controls raises concerns about identity, purity, and actual content in products marketed online.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Visual inspection is not sufficient for identity. |
| Solubility | Soluble in DMSO and ethanol | Low solubility in water; stock solutions use organic solvent. |
| Storage | -20°C, desiccated, protected from light | Limits hydrolysis and photodegradation. |
| Analytical method | HPLC-UV/MS | Used for identity and purity assessment. |
| Synonyms | SR9009, Stenabolic | Naming varies by supplier. |
SR9009 is a synthetic small molecule studied as an agonist of the nuclear receptors REV-ERBα and REV-ERBβ. These receptors help regulate circadian rhythms and metabolic gene expression. In laboratory experiments, SR9009 binds these receptors and alters transcription of genes involved in lipid handling, glucose metabolism, and mitochondrial function. It is not a naturally occurring compound and has no approved therapeutic use. Research interest stems from its ability to modify energy metabolism in cells and animal models.
In rodent studies, SR9009 has been reported to increase mitochondrial content in skeletal muscle and improve exercise endurance under some conditions. These findings led to popular descriptions such as an exercise mimetic, although that term oversimplifies the biology. Effects vary by dose, timing, tissue, and model. The compound's influence on circadian pathways means that time of administration can matter in experiments. Whether similar metabolic changes occur in humans remains largely unexplored in controlled published trials.
Cereulide 2-methyl-5-HT Alpha-Methyltryptamine Bufotenin Chlorophenylbiguanide Ibogaine Phenylbiguanide Quipazine RS-56812 – Potent and selective 5-HT3 partial agonist, 1000× selectivity over other serotonin receptors SR-57227 Varenicline YM-31636 S 21007 (SAR c.f. CGS-12066A)
Comfrey, which contains alkaloids which may be harmful to the liver from chronic use, and particularly is not recommended during pregnancy or when prescription drugs are used; comfrey is not recommended for oral use. Lobelia, which contains alkaloids and has traditional medicine uses for smoking cessation, may cause nausea, vomiting, or dizziness at high doses. Herbal teas can also have different effects from person to person, and this is further compounded by the problem of potential misidentification. The deadly foxglove, for example, can be mistaken for the much more benign (but still relatively toxic to the liver) comfrey. Care must be taken not to use any poisonous plants. The US does not require herbal teas to have any evidence concerning their efficacy, but does treat them technically as food products and require that they be safe for consumption. Fruit or fruit-flavored tea is usually acidic and thus may contribute to erosion of tooth enamel.
=== High-resolution melting of the entire amplicon === High-resolution melting analysis is the simplest PCR-based method to understand. Basically, the same thermodynamic properties that allowed for the gel techniques to work apply here, and in real-time. A fluorimeter monitors the post-PCR denaturation of the entire dsDNA amplicon. You make primers specific to the site you want to amplify. You "paint" the amplicon with a double-strand specific dye, included in the PCR mix. The ds-specific dye integrates itself into the PCR product. In essence, the entire amplicon becomes a probe. This opens up new possibilities for discovery. Either you position the primers very close to either side of the SNP in question (small amplicon genotyping) or amplify a larger region (100–400bp in length) for scanning purposes. For simple genotyping of an SNP, it is easier to just make the amplicon small to minimize the chances you mistake one SNP for another. The melting temperature (Tm) of the entire amplicon is determined and most homozygotes are sufficiently different (in the better instruments) in Tm to genotype. Heterozygotes are even easier to differentiate because they have heteroduplexes generated (refer to the gel-based explanations) which broadens the melt transition and usually gives two discernible peaks. Amplicon melting using a fluorescently-labeled primer has been described, but is less practical than using ds-specific dyes due to the cost of the fluorogenic primer. Scanning of larger amplicons is based on the same principles as outlined above.
Sources: en.wikipedia.org
== Career == Henriksen found work as a muralist and as a laborer on ships. For a time, he worked in Europe. Around age 30, he found theater work as a set designer, and he received his first acting role because he built the set for a production. It was around this time that he taught himself to read. For his first role, he put the entire script on tape with the help of a friend, then learned his part and all of the others. Soon afterward, he graduated from the Actors Studio and began acting in New York City. Henriksen's first film appearance was in The Outsider in 1961, as an uncredited extra. He received his first credit in his second film, 1972's It Ain't Easy. He auditioned for the role of Leon Shermer in Dog Day Afternoon (1975), but received the smaller part of an FBI agent that kills John Cazale's character. He appeared in two more films directed by Sidney Lumet: Network (1976) and Prince of the City (1981). In a 2009 interview, Henriksen called Lumet "the kind of guy that loves New York actors, because that's where he works and that's what he knows....He would give you the job that was maybe only meant for four days, and he'd give you the run of the show because he wanted to help support young actors in New York." Henriksen had supporting roles in a variety of films, including the science-fiction film Close Encounters of the Third Kind (1977) and the horror film Damien - Omen II (1978). He also had co-starring roles in the low-budget horror film Mansion of the Doomed (1976) and the Italian-produced science fiction film The Visitor (1979).
=== Other potential applications === As a highly scattering material for ultra-white coatings Activate the dissolution of cellulose in different solvents Regenerated cellulose products, such as fibers films, cellulose derivatives Tobacco filter additive Organometallic modified nanocellulose in battery separators Reinforcement of conductive materials Loud-speaker membranes High-flux membranes Computer components Capacitors Lightweight body armour and ballistic glass Corrosion inhibitors Radio lenses Art Conservation
=== Inscribed squares === An acute triangle has three inscribed squares, each with one side coinciding with part of a side of the triangle and with the square's other two vertices on the remaining two sides of the triangle. (A right triangle has only two distinct inscribed squares.) If one of these squares has side length xa and another has side length xb with xa < xb, then
Sources: en.wikipedia.org
Liquid chromatography with mass spectrometry is a common approach. Ultraviolet detection and nuclear magnetic resonance can support identification when suitable standards are available.
The solid is generally kept cold, dry, and protected from light. Solutions are often frozen in single-use aliquots to reduce repeated freeze-thaw cycles.
It indicates a material sold for laboratory study, not for human use. The label does not guarantee pharmaceutical purity, sterility, or regulatory approval.
Liquid chromatography–mass spectrometry is common for identity and purity checks. High-performance liquid chromatography with ultraviolet detection can also be used. Both methods require a suitable reference standard.